Menu:
Post Machines Wanted - Charts  - Contact Us 
Home | Gallery | New Machines | Used Machines | Parts/Tooling | Leasing | Service | Advertising
Inquire & Order Parts
Iron Worker Punches & Dies Inquiry
Shear Blades Inquiry

Aaa read this before brow - Comparison of a Folder & a Press Brake, ID#FOLDERS VS PRESS BRA


Folding: Bending sequence
During the folding sequence the blank rests on the sheet support table. A gauging system positions the part to the bend line. The upper and lower beam clamp the blank. During the bending cycle the folding beam moves up around a pivot point. On up-down acting machines, the folding beam moves upwards or downwards, depending on the bending direction.

The part rests on the table (no fatigue, short cycle times)
The gauging system positions the part to the bend line (operator training finished in no-time)
Upright posture, easy operation (no health problems)
Usually one operator is sufficient even for large, cumbersome and heavy parts (low labor/parts costs)
 Part positioning
 Part clamping
 Folding



Please Fill Out the Following Information
ID#
Fax me a quote.
Send literature.
Please have a salesman call.
Company:
 
Name:
 
Address:
 
City:
State: Zip:
Country:
 
Phone:
 
Fax:
 
E-mail:
 
WWW Address:
 
WWW URL:
 

Home | Gallery | New Machines | Used Machines | Parts/Tooling | Leasing | Service | Advertising
Copyright © 2007-2018 Three Rivers Machinery. All rights reserved.
Three Rivers Machinery -- 1079 East Windhaven Road -- Pittsburgh, PA 15205 -- Map
Phone (412) 921-2800 7AM-5PM EST -- 24/7 Fax (412) 921-2801 -- info@sheetmetalmachinery.com